|
| Exhaust damper for 1956 BelAir |
Wanted |
Will pay what the cost is plus shipping. |
 |
| I am needing an exhaust damper for the passenger side. I really don't think the which side matters... it doesn't need the butterfly part in it, because I mainly need the housing for it so I can get the right distance (spacer) in there to put the exhaust back together and start driving it again. The idiot that supposedly rebuilt it in Phoenix, AZ left it out (and that was only a minor thing he did compared to all the rest he messed up---Dad's Engine Rebuilding, that was the names he went under before he had to leave Flagstaff, AZ because of his hideous/crappy work. Thanks and need this ASAP |
| 56 dash section for heater control unit |
Wanted |
|
|
Need the dash section from a 56 dash to weld into my RHD 55/56 dash on my 57 2DHT for the heater control unit.
Would need the item to be sent by USPS to Australia. |
| Vintage Chevy muscle car brochures available |
For Sale |
various |
 |
I have a few vintage Chevy brochures available if there is any interest out there?
Thanks,
Ed
please e-mail for the list
uptonlevyrtg@yahoo.com |
| 1952 Chevy Front End Suspension |
For Sale |
75obo |
|
| Going in the scrap heap? Let me know if you want it, removed and replaced with Mustang II..... |
| WANTED: 1963 Impala Station Wagon Trim |
Wanted |
|
|
Looking for an NOS or excellent (and I mean excellent) drivers side cove trim for an Impala wagon to complete my 63. The GM part number is 4882558.
I may also be interested in NOS door and front fender aluminum trim for the same car preferably with a white painted center. 4 door sedan and hardtop will interchange.
Thanx,
Andy |
| Rebuilt 283 (1960) |
For Sale |
2000.00 |
|
| I have a rebuilt 283 engine removed from my 1960 El Camino. I replaced the engine with a 409. The engine has less than 1000 miles on it. Engine is complete with a new 2bl carb. I also have the 1960 bell housing, starter that bolts to the housing and 3 spd manual transmission. I will sell the engine for $2000. The other items are negotiable. Engine is located in Panama City, FL |
| WTB 1935/36 short RH taillamp stand |
Wanted |
|
|
I need to purchase a RH '35/36 Chevy short taillamp stand, to be used for the pattern in making reproduction stands.
I used to make them, but a fire destroyed my tooling.
Or, if I could borrow a stand for 2 weeks, I will give the owner 2 reproduction stands for the use, plus your original back, unharmed. |
| WTB: Outside Visor |
Wanted |
|
|
| I'm looking to buy a visor for a '54 Chevy. Fulton style or factory original. |
| * Wanted* Haynes Manual for 90 Suburban |
Wanted |
$15.00 (includes shipping costs) |
|
I'm looking for a Haynes manual that covers the 90 GMC Suburban. I already have the Chilton's so don't need it. Used is fine and don't care if it's dog eared, stained etc. as long as all the pages are there and readable. Can pay $15.00 (includes shipping costs) via Pay Pal, money order or check.
Thanks,
Paul |
| 1967 RS camaro fender nos |
For Sale |
500.00 |
|
| I have a left side camaro nos fender I would like to trade for a 68.I know about cutting the marker light , but this rs fender has emblem holes that are not correct for my 68. The fender is perfect..thanks,,,I also have a pair of nos inner fenders that are also perfect for 500.00 and not negotiable..thanks |
| Aeromotive Fuel Pump |
For Sale |
250.00 plus shipping |
 |
| For sale is an Aeromotive fuel pump P/N 11106 and the inlet fuel filter (100 micron) P/N 12304. These are new and have never been used. The fuel pump sells from Jegs for $320 and the filter is $100. It also comes with 8 AN fittings on each end. For sale is what you see in the picture. Aermotive calls this their "700 HP" fuel pump. Great deal, save a lot of money. |
| TFS TWISTED WEDGE Heads for SBC |
For Sale |
$800.00 |
 |
| I have for sale a set of Trick Flow Systems Twisted Wedge heads for a Small Block Chevy... These are for 60s to 80s heads... They have been installed and run for about 500 miles and are in EXCELLENT condition. I have attached a pic, but if you need more, let me know... Write me at skeeterpow@excite.com. Also have a Victor Jr intake... ASK... I am asking $800.00 for the heads, but feel free to make me an offer... |
| Original Vintage Chevy, Corvette, Camaro Brochures |
For Sale |
|
|
| Website features great selection of original, vintage dealer brochures for Chevy - including Corvette and Camaro as well as Ford, Chrysler, other GM and imports. www.tomsautoliterature.com or contact tomfog1@gmail.com. |
| Rare Early Mickey Thompson M/T valve covers |
For Sale |
175 + shipping |
|
Vintage pair of EARLY M/T 427 big block chevrolet valve covers part #3276396. No cracks, welds, extra drilled holes. All the drippers are intact. Only the EARLY versions of these covers had the cubic inch designation! It appears they haven't been mounted on an engine. We even have the original shipping box from Mickey Thompson.
Pics available upon request. The pics I have are beyond the size limit for this site. |
| WTB: '68 Impala SB Fan Shroud |
Wanted |
|
|
I'm looking for a fan shroud, '68 Impala s/b with a/c.
Thanks |
| Seatbelt Wanted |
Wanted |
? |
|
| Need a black seatbelt for a 64 2 door Impala, bench seat, passenger side. |
| '57 Corvette Dual Point distributor non tach drive |
For Sale |
$425.00 + shipping |
|
1957 corvette dual point,non tach drive. for 283-220hp & 283-270 hp.Complete with oil tube ,cap,rotor,points & condensor. Anderson/DELCO-REMY TAG very good condition. i'm sure it needs cleaned,as it has been on Dad's shelf for over 40 years. Numbers are: 110891 dated; 6 J 12.$425 FOR DISTRIBUTOR
+ SHIPPING
ALSO HAVE:1962 CORVETTE 327 FUEL INJECTION SHORT BLOCK W/ THE RIGHT CRANK,RODS,PISTONS AND HDW & 461X HEADS. THE BLOCK HAS PROPER FI CODE & SERIAL #. NEEDS REBUILT. THE HEADS MATCH THE BLOCK TO BUILD YOURSELF A CORRECT #'S MATCHING LONGBLOCK ASSEMBLY. + 62 BORG-WARNER 4SPEED TRANS |
| 2 - CHEVELLE / CAMARO 12 BOLT AXLES {USED} |
For Sale |
$150.00 + shipping |
|
1 PAIR OF GM MIDSIZE 12 BOLT & HEAVY DUTY 10 BOLT AXLES. FOR;68-72 CHEVELLE & 70-81 CAMARO. 12 & 10 BOLT WITH THE HEAVY DUTY REAR END.
GOOD USED CONDITION,,"NOT TWISTED". |
| NOS CHEVY 12 BOLT AXLE,FULL SIZE CAR,'65-'72 |
For Sale |
$80.00 + shipping |
|
1- ONE NOS 12 BOLT AXLE FOR '65-'72 FULL SIZE
FACTORY TAGGED & BEARING SURFACE IS WRAPPED IN FACTORY CARDBOARD SLEEVE. MORE DETAILS AVAILABLE SEND E-MAIL FOR PHOTOS,,,AS MY PICS ARE TO LARGE FOR THIS SIGHT |
| 55-64 rear ends 3.36 4.10 3.08 posi |
For Sale |
599.00 |
 |
10 bolt 55-64 chevy drop out third member posi rear ends.
3.36 posi 599.00
4.10 posi 599.00
others can be built if you need.
Shipping is always available
330 659 7117
Richfield, Oh |
| '51/'52 Powerglide Transmission |
For Sale |
$30.00 |
 |
This transmission has been stored inside for at least twenty five years or so.My Dad and I removed it from a '51 hardtop and kept it as a spare for my '52 Styleline "just in case" we ever needed it.Before being removed,the car it came out of ran fine.After all these years,I would assume it's gonna need rebuilt.I've tripped over it long enough.
This is located in Taneytown,MD.21787 and will need to be picked up.I will NOT ship nor will I strap it to a pallet to be picked up by a shipping company.It's not worth the hassle.
|
| 57 Small parts |
For Sale |
negoitable or trade |
|
I have a lot of 57 Chevy small hard to find parts. Stick shift steering column, E-brake parts, brackets, etc. left over from the 57 Resto.
Call me for your needs. I need a 56 grille and bumpers plus side trim for a 210 Tudor. |
| OTC Nemisys Scan Tool |
For Sale |
400.00 |
 |
| Im selling my OTC Nemisys Scan Tool it is up dated to 2003 and has ABS, Body, Engine & Transmission code and data reader it also has global OBDII that will work on any car that has OBDII. Comes with OBDII and OBD1 for Ford, Jeep, Chrysler, Dodge, and GM cords, a hard case and manuel. If you have any questions please email, call or text me i check it all the time. It is in very good condition screen work perfect is looks new. I'm selling because i'm getting a new scanner. I'm asking $400 OBO I will ship with FedEx with insurance of $400. Thanks for looking Jason 208-818-1566 |
| 56 Bel Air Front Drum Brakes |
For Sale |
$100.00 |
|
| Set of Front Drums, semi metallic pads, new cylinders, self adjusters. All like new. Can send pic if interested. $100.00 plus freight. Changed over to disc. |
| 66 chevy parts |
Wanted |
|
|
| Im looking for the inner fender parts for 66 chevy truck and radiator support Thanks Jeff |
| 1953 sterring box an column |
For Sale |
225.00 |
|
| was just rebuilt |
| chevy part,s for sale |
For Sale |
open |
|
| lot,s of chevy part,s for sale, any year, large varity, ov 35 year,s collecting, also stering wheel, stering console, stering column restoring,polishing, straighting of all types of molding,s, call |
| 1958 Bel Air side trim |
Wanted |
|
|
| Looking for 'driver' condition 58 Bel Air side trim. Changing a Biscayne trim to Bel Air trim (looks better) for a two-tone paint job. Car is mostly original with pitted chrome, prefer side to be less than perfect. Looking for a fair and reasonable deal, nothing brand new that costs more than I paid for the car. |
| Thule Evolution 2100 Cargo roof carrier |
For Sale |
275.00 b/o |
 |
| This is a used Evolution cargo carrier. Gutter roof racks also available. A few scratches, key locks work from both sides. This is the cargo box that can be opened from either side. Vary aero dynamic, you won't even know it is there. Over 18 cubic feet of storage. Large enough for ski's, golf clubs, surf boards, etc. Email me for more pic's or info. Asking 275.00 b/o. |
| WTB 1929 Maryland License plate SET |
For Sale |
$1 up |
|
I am looking for a set of 1929 Maryland license plate .does anyone have ??
Thanks
Dan |
